BERNINA 700 – muhteşem nakış için kesinlikle en iyi makine

The embroidery motif is too dense or not dense enough

The embroidery motif should not be enlarged or reduced on the machine by more than 20%.

What embroidery formats can be used?

Formats of various brands can be used:
EXP, DST, PES, PEC, JEF, PCS, SEW, XXX

When positioning the motif, the hoop does not move

The function "Virtual positioning" was not activated when selecting the hoop. Activate the function so the hoop moves during positioning.

What is the yellow bobbin case for?

This is a specially developed bobbin case with high thread tension for the BERNINA hook that is particularly suitable for embroidery and quilting.

When does the hoop have to be calibrated?

When the machine is used for the first time.
If the center needle position does not match with the actual center of the motif.

When embroidering, the connecting stitches are not cut

The "Cut connecting stitches" icon in stitching mode is not active.
The cut length of the connecting stitches is set too high. To change this, go to "Setup", "Embroidery settings", "Automatic cut" and reduce the value.

The machine does not start embroidering

The attached Embroidery foot #26 and the needle plate have to be selected.

How do I decide which hoop to use?

Always use the smallest possible hoop the motif will allow.

Why are there two different colors of hoop templates?

The purple or orange template is used, depending on the model.
 

The outline of the motif is skewed

Use the right kind of stabilizer and, if necessary, several layers depending on the fabric thickness.

From which model upwards can the Maxi and Jumbo Hoops be used?

From the 7-Series, although the Jumbo Hoop will have a limited embroidery area.

The screen is not responding

The screen needs calibrating. Select "Setup", "Machine settings" and "Display calibration" and follow the instructions on the screen.

How much thread is still on the BERNINA Jumbo Bobbin when the sensor indicates that the thread is running out?

A Jumbo Bobbin holds approximately 100 m, depending on the thread. The lower thread sensor notifies you when there is 10% of the thread remaining. This means that there is still approximately 10 m of thread on the bobbin.

The upper thread indicator reacts even when the upper thread is not broken

Check if there are any pieces of loose thread in the path of the upper thread and remove them.

The upper thread indicator is not responding

The upper thread indicator has been deactivated in "Setup". Select "Setup", "Monitoring functions" and "Activating the upper thread indicator".

The lower thread indicator is not responding

There may be several reasons for this:
The door of the hook cover is open. Close it.
The sensor of the lower thread indicator is dirty and needs cleaning.
The lower thread indicator has been deactivated in "Setup". Select "Setup", "Monitoring functions" and "Activating the lower thread indicator".